General Lab Equipment
Glass tube oven GTO-3000 Drying Type
This is a vacuum heating device that has a lineup of two types: a rotating heating type that can provide a small amount of samples and concentrate and concentrate a small amount of a small sample and a drying type for drying a sample. The GTO-3000 type is a high-end model that scales up while keeping the basic specification of the GTO-2000 type. By adopting a heater tube with about 3 times the volume compared to the GTO-2000 type, it also supports a high-capacity sample.
● The maximum temperature can be set to 350 ° C. ● Glass coating heater with a vacuum jacket with high heat insulation ● Adjust the rotation speed by bolium knob ● Heater block with up to 45 degrees angle ● 1 pattern 9 steps 9 steps. A temperature rising program up to the pattern is possible. ● Sample processing amount is also increased by increasing the heater capacity ● Standard equipment with analog output that can connect to a commercially available recorder ● Saving operation in the event of abnormalities, various error display, and warning function The material of the club is PTFE, the Palo -ros is an O -ring, which increases the drug resistance. ● The display panel can be displayed in Japanese and English
.
● The maximum temperature can be set to 350 ° C. ● Glass coating heater with a vacuum jacket with high heat insulation ● Adjust the rotation speed by bolium knob ● Heater block with up to 45 degrees angle ● 1 pattern 9 steps 9 steps. A temperature rising program up to the pattern is possible. ● Sample processing amount is also increased by increasing the heater capacity ● Standard equipment with analog output that can connect to a commercially available recorder ● Saving operation in the event of abnormalities, various error display, and warning function The material of the club is PTFE, the Palo -ros is an O -ring, which increases the drug resistance. ● The display panel can be displayed in Japanese and English
.
Information by Item Code (Specifications)
Item Code | 050600-30002 | |
---|---|---|
Model | GTO-3000 Drying | |
Analog output | 0 to 400mv (0 to 400 ° C) | |
Heater capacity | Approximately 800W | |
Temperature control range | Room temperature + 5-350 ° C | |
Safety function | Heater disconnection warning, temperature sensor abnormality warning, over -temperature prevention function Rotating part abnormality warning (rotating heating type), upper and lower temperature abnormal warning |
|
Timer function | On -amer, off -timer (99 hours 59 minutes 59 seconds each) | |
Capacity of Drying tube | Approximately 920ml (outer dimension φ70 x 325mm) | |
Capacity of Desiccant flask | Approximately 170ml | |
Temperature sensor | Platinum measurement temperature resistor 3 wires 100Ω | |
Temperature control method | PID control | |
Mass | About 16kg | |
display | LCD display with backlight (20 digits x 4 lines) | |
Program function | 9 steps (1 step: 99 hours 59 minutes 59 seconds) x 9 patterns can be registered | |
Reaching vacuum degree | 1.3HPA (at 10rpm) | |
Operating Environment | 5-35 ° C | |
Power Supply | AC100 to 240V 50/60Hz 800VA | |
Size | 680 (W) x 250 (D) x 425 (H) mm | |
Price (excluding tax) | Contact us | |
Note |
Related information
- catalog
- Manual